Inserting SIM card
Please proceed through these steps only if you received drone without SIM card, or you want to change it.
The LTE module supports Nano SIM cards only!
Remove screws holding right side panel
Use hexagon screwdrivers to remove top, bottom and side screws marked in the pictures.
Open side panel
Open side panel at the front of the drone.
Slightly push side panel forward to unblock its rear side.
Be careful with the antenna wire connection to avoid tearing it off!
Insert SIM card
Insert nano SIM card with the chip facing down and notch facing forward as shown in the picture.
Properly inserted SIM card can be shown in the picture below.
Mount side panel back to the drone
Now you can mount side panel to its original place.
When mounting the side panel, pay close attention to the connection wires to avoid pinching or cutting them!
Last updated