Box content

Page navigation

DroneCore 1

• Box content - YOU ARE HERE

• Getting started

  • First time setup

  • Motor connection

    • Soldering motors

    • ESC configuration

    • ESC configuration APP (AMC Manager v1.0.0)

    • ESC configuration APP (AMC Manager v1.1.0)

    • Testing motors

  • Ardupilot setup for power boards

• Pilot boards

  • DCS1.Pilot v1.0

    • Power supply

    • Peripherals

    • Connectors and pinouts

  • DCS1.Pilot v1.2

    • Power supply

    • Peripherals

    • Connectors and pinouts

• Power/PDB boards

  • DCS1.Power

    • Power supply

    • Peripherals

    • Connectors and pinouts

    • Octocopter configuration

    • .Power board diagnostics

    • Board firmware update

Since DCS1 offers a lot connection options, it is desirable to have some useful peripherals and cables at hand from the beginning.

DCS1 is supplied with accessories:

• PWM adapter - adapter to connect standard JR connectors used for PWM output, typically for motor control

• Interconnection cable (JST GH-8) for PWM adapter 6cm

• Interconnection cable (JST GH-8) for PWM adapter 12cm

• USB type A adapter (2pcs)

• LVDS 15pin flat cable, 15.2cm

• LVDS 15pin flat cable, 10cm

• Ethernet adapter

• 16pin flat cable, 15cm

• USB adapter Alink - USB to 3pin serial port converter used to configure USB (provided with DroneCore.Power); aditionaly common USB micro cable with data transfer functionality is needed

• 3 wire cable to connect USB adapter Alink with DroneCore.Power (provided with DroneCore.Power)

• JR to JST GH-3 cable for receiver connection

• Cable for power button JST GH-3 with 2 wires (provided with DroneCore.Power)

DroneCore.Suite box content with DroneCore.Power

DroneCore.Suite box content without DroneCore.Power

Additional recommended accessories

• USB micro cable to configure Cube flight controller and establish connection with Jetson Xavier NX

• Heatsinks for DroneCore.Power (recommended for total power over 25A)

• USB type C adapter

• USB micro adapter 3.0 (wide)